#Set inform unifi password#
When I try to adopt it in the controller, it tries, but always fails. SSH to your Unifi ap ssh ubntyouripaddress default password is ubnt.
But than after some days and a new set-infom it just states “not adopted”. When done correctly the output will state the following: UnifiAC-LRBaseStation-BZ.v4.3.24 set-inform Adoption request sent to 'http://FQDN:8080/inform'. Make sure to replace ' with your specific inform URL. make sure the Override inform host with controller hostname/IP box is checked. To set the inform URL you will need to run the command: set-inform. When I asked “info” it stated that there was an error with the inform server. The UniFi adoption process is 3 steps: Device set-informs to the server. sure the Override inform host with controller hostname/IP box is checked. I logged into the NanoHD via SSH en did set-inform. To finish setting up your UDM-Pro, please read UniFi - Set Up a Dream Machine. I disconnected it a few times from the switch by pulling the cable, but it will nog re-adopt. I noticed last week the NanoHD was blinking white and showed up in the controller as not adopted. Back in the controller UI, you should see the state change to Provisioning, then Connected.
Now go back to the SSH session connected to the USG and run the same set-inform command again (yes, you must run set-inform twice): 4. I’m running the controller in a docker container on my Synology disktation (on a fixed IP on 192.168.0.99, I’m limited due to my ISP provider, maybe in the futur I can run my own router).īoth unifi devices are running the latest firmware since today and the controller version is 6.0.43. Click on the Adopt link: The state of the USG should change from Pending Adoption to Adopting: 3. I have a unifi switch (US-8-60W), with a NanoHD for about 2 years, without any issues.
#Set inform unifi update#
After an update of my pi-hole, running on a raspberry pi, the pi-hile blocked a service " .com’, I’m not sure it is the source of the issue, but since then I noticed the problem.
0 kommentar(er)
